I purchased the cylinder to use on the tilt of my Tractors front end loader. The install was simple and straight forward. Simply install a pin at each end’ add the hydraulic lines and off we go. The cylinder worked well for the first load or so. Then the problem came when the cylinder shaft bent. Mind you the old cylinder on the other side never bent. So I called to get a return number. Just to learn that a bent shaft was not covered under warranty. I emailed the customer service lady’s supervisor only to get an email that said no warranty. The cylinder was nistalled wrong. So buyer beware if you buy the cheap China stuff be ready to replace it as when it breaks it will not be under warranty.
These rams were used for a Massey Ferguson front bucket loader. They had to be welded upon to refabricate proper connectors so to be installed upon the loader arm to bucket. My hope is to have a working hydraulic system in order to sell this 205 industrial tractor
From Robert W. on 2" bore x 8" stroke ag clevis hydraulic cylinder
From bobn on 2" bore x 8" stroke ag clevis hydraulic cylinder
From cSutton on 3.5" bore x 12" stroke ag clevis hydraulic cylinder
From Ben Coffman on 3.5" bore x 12" stroke ag clevis hydraulic cylinder
From Wheel Chair Mike on 3.5" bore x 12" stroke ag clevis hydraulic cylinder